75W Power Supply Module/USB Charger DC 6~32V to 1.25~32V 5A Buck Converter Adjustable Voltage Regulator DC 12V 24V Adapter/Driver Module + Dual Display Digital Meter

  • Item ID #180080
Qty.:

List Price: $23.50 Our Price: $9.75Save 59%

Price(per unit)
1-4
$9.75
5-9
$9.26
10-19
$8.78
20-29
$8.29
30+
$7.80
Buy More: please contact us

It is a 75W Power Supply Module/USB Charger + Digital Meter, Input voltage: DC 6~32V, Output voltage: DC 1.25~32V, Output current: 5A Max. It has small size, high efficiency, long term stable and reliable quality,easy installation and use, Suitable for DIY an adjustable voltage regulated power supply, Charging module, Industrial equipment Voltage convert, Power Supply Transformers, Laptop Power Supply, Batteries Buck, Car Power Supply, LED drive,Advertising screen,Monitoring System etc


Other Products in DC Buck/Step Down

page 1 of 2 Previous Page Next Page
Parameters:
  • Input voltage: DC 6~32V
  • Output voltage: DC 1.25~32V (Input must be 1.5 higher than output.)
  • Output current: 5A Max, adjustable, recommend the use of within 4.5A. (Over 2A or 35W, please enhance heat dissipation.)  
  • Constant current needs above 2V output voltage, then can be adjusted. Only in the status of constant current can current adjustment work.
  • Output Power: Max. 75W (recommend the use of within 50W, please reduce power if the dropout voltage is large)
  • Operating temperature: -20°c ~+70°c
  • Operating frequency: 180KHz
  • Conversion efficiency: up to 96%
  • Short circuit protection: Yes
  • Input reverse polarity protection: None
  • Over-temperature protection: Yes (Automatically shut off the output when over-temperature.)
  • Connection: terminals or solder terminals; VIN is input; VOUT is output
  • Module dimension: 65.6 x 40 x 25mm
Voltage-calibration Method:
  • In the case of power off, press and hold the "SET" key and power on, then enter into voltage calibration mode, and LCD screen starts to flash, release the "SET" key;
  • press "SET" and "ENT" key to increase or reduce the voltage to the right input voltage. It will automatically saves after 2s, then power off and the calibration is complete.
Current-calibration Method:
  • Suitable for no-load with current display or slightly large current. In the case of power off, press and hold "ENT" and power on, then enter into current calibration mode and LCD screen starts to flash, release the "ENT" key; press "SET" and "ENT" key to increase or reduce the voltage to the right value. It will automatically saves after 2s, then power off and the calibration is complete.
Package Includes:
  • 1 x DC-DC Adjustable Step-down Power Supply Module with Shell
  • 4 x Copper Cylinder Screws M3 x 6
  • 4 x Double-pass Screws M3 x 12
  • 8 x Roundhead Screws M3 x 6

Reviews

* Required information
Choose a ranking for this item. 1 star is the worst and 5 stars is the best.
NOTE: HTML tags are not allowed.
NOTE: Reviews require prior approval before they will be displayed